Schlage Touch FE695 Instrucciones De Instalación página 2

2
Press levers onto lever posts.
Tip points
down
3
Remove battery cover from the interior thumbturn
assembly.
Unscrew the cover and lift down and out to remove.
4
Install the touchscreen on the outside of door.
Bar should slide smoothly through hole in latch. If not, check
door dimensions.
5
Install the interior lever assembly.
5a Route wire through indicated hole below.
IMPORTANT!
Route wire over the latch.
5b Secure interior assembly with screws.
6
Connect wire and battery.
7
Place battery in holder and tuck wires.
Tuck battery and wires behind the tabs.
Tabs
8
Install battery cover.
Angle the cover up to install, then screw the cover in.