Installation Instructions – Night Falcon/UFLD
Wire Guard (Figure 6.)
Tools Required
Phillips screwdriver
1.
Loosen and remove the existing (4) 10-24 Philips head
screws on the face of the fixture and retain for future
reference.
2.
Align wire guard on top of lens clips matching the four
existing holes. (Figure 6.)
3.
Retighten (4) 10-24 Philips head screws from step 1 to
the face of the fixture.
4.
To remove wire guard follow steps 1-3 in reverse order.
Vandal Shield (Figure 7.)
Tools Required
Phillips screwdriver
1.
Loosen and remove the existing (4) 10-24 Philips head
screws on the face of the fixture.
2.
Align (4) 7/8" spacers with existing holes.
3.
Use (4) 10-24 x 1-1/2" screws to secure vandal shield
on top of fixture. (Figure 7 .)
4.
To remove vandal shield follow steps 1-3 in reverse
order.
Visor (Figure 8.)
Tools Required
Phillips screwdriver
1.
Loosen and remove the existing (4) 10-24 Philips head
screws on the face of the fixture and retain for future
reference.
2.
Align visor on top of lens clips matching the 4 existing
holes. (Figure 8.)
3.
Retighten (4) 10-24 Philips head screws from step 2 to
the face of the fixture.
4.
To remove visor follow steps 1-3 in reverse order.
4
EATON
IB506007EN
Installation instructions
Figure 6.
Figure 7.
Figure 8.