SANUS VuePoint F11c Manual De Instrucciones página 13

3. Remove the wall plate template
CAUTION:
Be sure the anchors are seated flush with the concrete surface.
15
4. Install wall plate using two lag bolts
CAUTION:
Improper use could reduce the holding power of the lag bolt. DO NOT over-tighten the lag bolts
*
Contact Customer Service at 1-888-333-9952 to have the Concrete Installation Kit CMK2 shipped directly to you.
NOTE: If needed, you can make small level adjustments to the wall plate by loosening the bottom lag bolt
16
Tighten the bottom lag bolt
3
14
and insert two anchors (Fischer UX 10 x 60 - included in the Concrete Installation Kit CMK2*).
16
. Tighten the lag bolts only until they are pulled firmly against the wall plate.
when adjustments are complete (see page 11).
*
4
16
16
.
16
and shifting the wall plate until level.
15
13