Fan Assembly. Pgs - Craftmade TIM54ABZ Guia De Instalacion

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5. Fan Assembly.
If you wish to extend the hanging length of your
fan, you must remove the hanging ball from the
downrod provided to use with an extended
downrod (sold separately). [If you wish to use the
downrod provided, please proceed to instructions
on the following page.]
To remove hanging ball, loosen set screw on
hanging ball, lower hanging ball and remove
stop pin. Slide hanging ball off the original
downrod, A, and slide it down the longer
downrod, B (the top of the downrod should be
noted as having a set screw hole; use this hole
when setting the set screw). Insert stop pin into
top of extended downrod and raise hanging ball.
Be sure stop pin aligns with slots on the inside of
the hanging ball. Tighten set screw securely.
[Refer to diagram 1.]
Install the 4 candelabra base bulbs provided into
sockets located in top of motor housing. [Refer to
diagram 2.]
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of
electrical tape to the ends of the electrical
wires--this will keep the wires together when
threading them through the downrod.
Locate canopy cover in hardware pack. Loosen
yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor
housing yoke. Slide downrod through canopy,
canopy cover, downrod accessory and yoke
cover. [Refer to diagram 3.]
Note: Canopy cover must be turned with shiny
side toward the motor.
Thread electrical wires and safety cable through
downrod and pull extra wire slack from the
upper end of the downrod. [Refer to diagram 3.]
Thread downrod into the motor housing yoke
until holes for pin and clip in downrod align with
holes in yoke--make sure wires do not get twisted.
Securely tighten yoke set screws and nuts. Lower
yoke cover and downrod accessory to top of
motor housing. [Refer to diagram 3.]
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and instructions
appearing in the manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are necessary
factors in the installation and operation of this fan.
set screw
A
diagram 1
bulb
sockets
diagram 2
electrical wiring
canopy cover
yoke cover
pin
diagram 3
page 4
set screw hole
stop pin
hanging ball
B
motor housing
safety cable
downrod
canopy
downrod accessory
yoke set screw
housing
clip
motor

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Tim54bnk

Tabla de contenido