Important; Canopy Assembly - Craftmade TIM54ABZ Guia De Instalacion

6. Wiring. (cont.)
IN ORDER TO WIRE WALL CONTROL, remove
existing wall switch. Wire the WALL CONTROL
with wire connectors provided as shown in
diagram at right.
* Wrap each wire connector separately with
electrical tape as an extra safety measure. Gently
push wires and taped wire connectors into outlet
box.
Use a ballpoint pen or a small screwdriver to set
the code switches 1 through 4 on the wall
control. Factory setting is pre-set and not
recommended for use. Write down number
sequence for use in Section 10.
Note: Since this fan comes with candelabra base
bulbs, the dimmer switch (labeled D and X) has
been pre-set to the "ON" position (D). If you do
not wish to have dimming capability, please
move the switch to the "OFF" position (X).
Install one 12-volt battery (included) in wall
control. Attach wall control to outlet box and
secure with screws from original wall switch.
Attach front plate to wall control using 2 screws
provided with the wall control.
IMPORTANT: Wall control will not function
unless battery is installed.

7. Canopy Assembly.

Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded
part of slotted hole in canopy over loosened
screw in hanging bracket and push up. Twist
canopy to lock. Re-insert screw that was removed
and then tighten both screws securely. Slide
canopy cover up to canopy, aligning rounded
part of slotted holes in canopy cover with screw
heads in bottom of canopy. Turn canopy cover to
the right (clockwise) until it stops.
*Remember that antenna for remote control
receiver must rest outside of hanging bracket.
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
outlet box
green/ green/ green/
bare bare bare
ground ground ground
black
black
(AC IN from
breaker box)
(wiring for wall control)
receiver
canopy
screw
page 6
wall
control
-
-
green
black (OUT to fan)
black
(TO POWER supply)
12V battery
antenna
hanging bracket
screw
canopy cover
plate
1 1
code
switches
2 2
dimmer
switch