QSC DAB-801 Manual De Instalación Del Hardware página 10

Backup 2-Channel Amplifier Connections
EN
Backup 2-Channel Amplifier DataPort Connections
To attach a backup 2-channel amplifier to the DAB-801, connect a male to male QSC DataPort cable from the HD-15 connector labeled "Backup
Amplifier DataPorts" on the DAB-801 to the HD-15 DataPort connector on the amplifier.
Primary and backup amplifiers must be of the same type and channel count.
It is mandatory that the backup DataPort labeled "X" on the DAB-801 be used for this.
Backup 2-Channel Amplifier Output Connections
Wire the outputs of the backup amplifier to the green detachable terminal block labeled "Connect to Backup Amplifier" on the DAB-801. The output of
backup amplifier "X" should connect to the section of detachable terminal block that is labeled "X."
Backup speaker connections "Y" should be left open.
10