QSC DAB-801 Manual De Instalación Del Hardware página 8

Backup I/O Frame Connections
EN
Backup I/O Frame GPIO Connections
If a backup I/O Frame is used (optional), connect a male to male DB-15 cable from the GPIO port on the backup I/O Frame to the DAB-801 DB-15
connector labeled "Backup Q-Sys GPIO."
2-channel backup amplifiers must use the DataPort labeled "X" on the DAB-801. DO NOT USE DATAPORT "Y."
Backup I/O Frame DataPort Connections
If a backup I/O Frame is used (optional), connect its HD-15 connectors to the DAB-801 using QSC DataPort cables. Backup DataPort connections
should be made from I/O Frame to the upper and innermost HD-15 connections on the DAB-801. These connections are labeled "Backup Q-Sys
DataPorts" and are designated with letters A-D.
It is important that the connections from the primary and backup I/O Frames are identical. If port A on the primary I/O Frame
connects to primary port A on the DAB-801, then port A on the backup I/O Frame must connect to backup port A on the DAB-801.
8
Q Sys Frame
TM
DAB-801