Getting Started - Waterpik WP-60 Manual Del Usuario

Ocultar thumbs Ver también para WP-60:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Powering the Unit
Plug the cord into an electrical outlet. If the outlet is controlled by a wall
switch, be sure it is turned on.
Preparation and Use
Refer to the Quick Start Guide for proper use instructions.
When Finished
Turn the unit off. Empty any liquid left in the reservoir. Unplug the unit.
TIP USAGE
Pik Pocket™ Tip
The Pik Pocket
Tip is specifically designed to deliver water
or anti-bacterial solutions deep into periodontal pockets.
Tip, set the unit to the
To use the Pik Pocket
lowest pressure setting. Place the soft tip
against a tooth at a 45-degree angle and gently
place the tip under the gumline, into the pocket.
Turn the unit on and continue tracing along the gumline.
Tongue Cleaner Tip
To use the tongue cleaner tip, set to lowest pressure
setting, place tip in the center/middle of your tongue
about half way back and start the Water Flosser. Pull
forward with light pressure. Increase pressure as you prefer.
Using Mouthwash and Other Solutions
Your Waterpik
Water Flosser can be used to deliver mouthwash and
®
antibacterial solutions. After using any special solution, rinse unit to prevent
clogging by partially filling reservoir with warm water and running the unit
with tip pointed into sink until unit is empty.
7

GETTING STARTED

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Wp-65Wp-70

Tabla de contenido