Cebora SYNSTAR 270 T SRS edition Manual De Instrucciones página 19

1 - DISPLAY.
This displays both the welding parameters and all the
welding functions.
2 - KNOB
Selects
welding functions and parameters.
3 - CENTRAL ADAPTER
This is where the welding torch is to be connected.
4 – SOCKET (-)
For connecting the earth cable connector in MIG welding,
MMA welding and a TIG welding torch.
5 – CONNECTOR (-)
For connecting the cable with the earth terminal. Place it as
close as possible to the working area.
6 – CONNECTOR
USB-type connector to be used for updating the welding
programs.
7 - FITTING
This is where the gas hose from the TIG torch is to be
connected.
8 – CONNECTOR
This is where the control cable of the Push Pull welding
torch and the TIG torch control cable is connected.
9 – SOCKET (+)
Socket for connecting the earth cable connector in TIG wel-
ding and the electrode holder in MMA welding.
10 – FUSE HOLDER
4 CONTROLS LOCATED ON REAR PANEL.
0 1
V
11
13
and
10 – FUSE HOLDER
11 – GAS PIPE CONNECTION
12 – SWITCH.
adjusts Starts and stops the machine
13 – MAINS CABLE.
14 – PRESSURE SWITCH CONNECTOR.
Connector to which the cable from the cooling unit Item
No 1681 (optional) is connected.
15 – SOCKET.
Socket to which cooling
unit Item No 1681 (optional) is connected.
5 START UP AND INSTALLATION
• Position the welding machine so as to allow the free cir-
culation of air inside and, as far as possible, to prevent
metal or other dusts from entering.
• The machine must be installed by professional person-
11
nel.
• All the connections must be performed in compliance
with applicable standards (IEC/CEI EN 60974-9) and
with accident-prevention laws.
12
• Make sure the power supply voltage corresponds to the
welding machine rating.
10
• The protection fuses must be sized according to the
details shown on the technical data plate.
• Position the cylinder on the support and fix it with the 2
straps; ensure that the straps are secured tightly to the
cylinder to prevent dangerous tilting.
• Connect the gas hose to the outlet of the pressure regu-
14
lator.
• Open the side door.
15
• Connect the earth cable to socket 4 and through the
terminal to the workpiece.
19