Accessories; Packing And Unpacking; Unpacking, Moving, Use And Storage; Setting To Work - Connection To The Power Supply - Nilfisk CTS22 Manual De Instrucciones

Accessories

Various accessories are available; refer to the manufacturer's
accessory catalogue.
WARNING!
ATEX-IECEx variant: refer to the manufacturer's sales
network.
WARNING!
Use only genuine accessories supplied and
authorized by the manufacturer.

Packing and unpacking

Dispose of the packing materials in compliance with the laws
in force.
Figure 3
Model A (mm)
CTS22 L, M 1.200
CTS40 L, M 1.200
CTT40 L, M 1.200
CTS22 H 1.200
CTS40 H 1.200
CTT40 H 1.200

Unpacking, moving, use and storage

Operate on flat, horizontal surfaces.
The load-bearing capacity of the surface the vacuum cleaner
is placed on must be suitable for bearing its weight.
07/2018
CTS22 / CTS22 L-M-H / CTS40 L-M-H / CTT40 L-M-H / CTT40 IECEx
B (mm) C (mm) kg
700 1.700 117
700 1.700 131
700 1.700 136
700 1.700 122
700 1.700 136
700 1.700 141
Setting to work - connection to the power
supply
WARNING!
■ Make sure there is no evident sign of damage to
the vacuum cleaner before starting work.
■
Before plugging the vacuum cleaner into the
electrical mains, make sure the voltage rating
indicated on the data plate corresponds to that of
the electrical mains.
■
Plug the vacuum cleaner into a socket with a
correctly installed ground contact/connection.
Make sure that the vacuum cleaner is turned off.
■ The plugs and connectors of the connection
cables must be protected against splashes of
water.
■ Check that for proper connection to the electrical
mains.
■ Use the vacuum cleaners only when the cables
that connect to the electrical mains are in perfect
condition (damaged cables could lead to electric
shocks!).
■ Regularly check there are no signs of damage,
excessive wear, cracks or ageing on the electric
cable.
WARNING!
When the vacuum cleaner is operating, do not:
■ Crush, pull, damage or tread on the cable that
connects to the electrical mains.
■
Only disconnect the cable from the electrical
mains by removing the plug (do not pull the
cable).
■
Only replace the electric power cable with one
of the same type as the original: H07 RN - F. The
same rule applies if an extension is used.
■ The cable must be replaced by the manufacturer's
Service Centre staff or by equivalent qualified
personnel.
5
GB
C313