Important Notice; Before Use; Connecting Your System - Pioneer Dolby Atmos SP-BS22A-LR Guia De Funcionamiento

English
2

IMPORTANT NOTICE:

number on the warranty sheet and keep it in a secure area for future reference.

BEFORE USE

• Thank you for buying this Pioneer
• Check your AV Receiver specifications for supported Dolby
Atmos speaker configurations.
• To assure maximum performance from your new speakers,
please read through this operating guide before you install
or use them. After you have finished reading this operating
guide, store it in a safe place for future reference.
• The nominal impedance of this speaker system is 6 ohms.
Connect the speaker system to a stereo amplifier with a
load impedance rating ranging from 4 to 6 ohms (a model

CONNECTING YOUR SYSTEM

IMPORTANT: Make sure all equipment is turned off before
making any connections. Correct wiring of your compact
speakers is essential for achieving the best sound quality. Be
careful to ensure proper polarity of connection. We recom-
mend a minimum of 18 gauge for runs up to 25 feet, and
thicker for longer runs.
Most compact speaker cable is coded to ease this task. Typi-
cally the ribbed or striped side, or the side with the connector
marked in red or white, is connected to the positive (red)
terminal. Make sure that the amplifier positive (red) terminal is
connected to the compact speaker positive (red) terminal, and
that the amplifier negative (black) terminal is connected to the
compact speaker negative (black) terminal.
If the wires you're using are not already terminated with banana
plugs, spade lugs, etc., strip off ½" of insulation from the ends
of the cable, twist the bare strands and insert into the binding
posts. Take care that no stray strands of wire short across
between the terminals.
Connect the cable from the front left or front right channel, or
the rear left or rear right channel, to the bottom set of binding
posts on the speaker.
If you are using the height channel drivers in the SP-BS22A-LR
for Dolby Atmos or another surround sound technology with
®
height channels, connect the cables for the corresponding
height channel (left front height channel of the receiver or amp to
The serial number for the equipment is located on the rear of the product. Please write this serial
product.
®
www.pioneerelectronics.com/Home
with "4-16Ω" displayed on the speaker output terminals).
• In order to prevent damage to the speaker system
resulting from input overload, please observe the
following precautions:
– Do not supply power to the speaker system in excess of
the maximum rated power.
– When connecting or disconnecting cables, be sure
amplifier power is OFF.
– Do not use excessive amplifier volume if using a graphic
equalizer to emphasize high or low frequencies.
the left front speaker's height channel input, right rear height
channel of the receiver or amp to the right rear speaker, etc.)
as seen below.
IMPORTANT: The top binding posts are for height channels only.
They must be driven from the channels on your Dolby Atmos
enabled receiver allocated for height, and with bass manage-
ment engaged that filters off any signals below 180 Hz.These
extra biding posts are NOT intended for
biamping.Failure to follow these instructions may result in
damage to the top drivers and void your warranty.