Important Notice; Before Use; Connecting Your System - Pioneer Elite SP-EC73 Guia De Funcionamiento

English
2

IMPORTANT NOTICE:

serial number on the warranty sheet and keep it in a secure area for future reference.

BEFORE USE

• Thank you for buying this Pioneer
• To assure maximum performance from your new center
speaker, please read through this operating guide before
you install or use it. After you have finished reading this
operating guide, store it in a safe place for future reference.
• The nominal impedance of this speaker is 4 ohms.
It must be connected only to an amplifier or receiver
designed to drive 4-ohm loads. Connect the speaker
system to an amplifier with a load impedance rating
ranging from 4 to 16 ohms (a model with "4-16Ω"
displayed on the speaker output terminals).

CONNECTING YOUR SYSTEM

IMPORTANT: Make sure all equipment is turned off before
making any connections. Correct wiring of your Speaker is
essential for achieving the best sound quality. Be careful
to ensure proper polarity of connection. We recommend a
minimum of 18 gauge for runs up to 25 feet, and thicker for
longer runs.
Most Speaker cable is coded to ease this task. Typically the
ribbed or striped side, or the side with the connector marked
in red or white, is connected to the positive (red) terminal. Make
sure that the amplifier positive (red) terminal is connected to
the loudspeaker positive (red) terminal, and that the amplifier
negative (black) terminal is connected to the loudspeaker
negative (black) terminal, as seen in the drawing.
If the wires you're using are not already terminated with
banana plugs, spade lugs, etc., strip off ½" of insulation
from the ends of the cable, twist the bare strands and insert
into the binding posts. Take care that no stray strands of
wire short across between the terminals.
The serial number for the equipment is located on the rear of the product. Please write this
Elite product.
® ®
• In order to prevent damage to the speaker resulting from
input overload, please observe the following precautions:
– Do not supply power to the speaker in excess of the
maximum rated power.
– When connecting or disconnecting cables, be sure
amplifier power is OFF.
– Do not use excessive amplifier volume if using a graphic
equalizer to emphasize high or low frequencies.
INSTALLING AND REMOVING THE GRILLE
The grille covering the drivers may be removed if desired,
as seen below.
To remove the grille, pull gently on it near one of its mounting
points. You don't need to pull the grille all the way out of its
grommet at first. Work your way around the grille, gently
working it loose around each mounting point. Once the grille
is completely loosened, you can remove it. To reattach it,
align the pegs on the grille with the holes in the speaker and
press in slowly around the mounting points until the grill is
pushed in all the way.
www.pioneerelectronics.com