Maintenance And Cleaning - THOMSON MIC100 Manual Del Usaurio

TROUBLESHOOTING AND CLEANING
Problems
No power
No sound
The appliance doesn't
start playing.
The remote control does
not work properly.

MAINTENANCE AND CLEANING

• Unplug the appliance before cleaning it.
• Remove fingerprints and dust with a soft and slightly damp cloth. Do not use abrasive products or solvents that may
damage the appliance's surface.
ATTENTION: Never immerse the appliance in water or in any liquid whatsoever.
• If it is not used for a long time, unplug the appliance and remove the batteries.
EN 12
Cause
• The power supply cable is
disconnected.
• The external source equipment is off.
• No disc has been inserted into the tray.
• The disc in the tray cannot be read.
• The disc is upside down.
• The disc is not inside the guide.
• The disc is dirty.
• The remote control is not pointed
towards the appliance sensor.
• The remote control does not activate
the appliance.
• There is an obstacle between the
remote control and the appliance.
• The remote control batteries are flat.
is a trademark of TECHNICOLOR S.A. used under license by:
Parsons International France - 19 Boulevard Albert Einstein
77420 Champs sur Marne - France
N°Azur
Monday to Thursday (from 9 am to 18 pm) and Friday (9 am to 3:30 p.m.)
www.thomsonaudiovideo.eu
MICRO SYSTEM
MIC100
• Correctly connect the power supply cable to
the mains socket.
• Turn the external power source equipment on.
• Place a disc in the tray.
• Place a legible disc in the tray.
• Position the readable side of the disc
downwards.
• Correctly position the disc on the tray, inside
the guide.
• Clean the disc.
• Point the remote control towards the
appliance sensor.
• The remote control has an effective range of 5
metres or the angle of aim is not correct.
• Remove the object.
• Replace flat batteries with new ones.
(+33 ) 0825 745 770
call rate according to operator
Solutions