Product Description; Safety Instructions - PLYMOVENT MOBILEGO Manual De Instalación Y De Uso

Motor design IEC
Energy efficiency n.a.
Mains cord 5 m
Plug: Type:
- 115V/1ph/50Hz - none
- 115V/1ph/60Hz - none
- 230V/1ph/50Hz - F
Welding fume class
W3 according to ISO 15012-1:2013
1.3.1 Dimensions
Refer to Fig. I on page 50.
1.4 Working range
Refer to Fig. II on page 50.
1.5 ambient and process conditions
Process temperature:
- min.
- nom.
- max.
Max. relative humidity
Suitable for outdoor use
1.6 Transport of the unit
You cannot hold the manufacturer liable for any transportation
damage after delivery of the product.
- Handle the filter unit and the accompanying extraction arm
with care.
- Completely dismount the extraction arm before transport.
Dismount the arm by executing the mounting procedure in
reverse order. Subsequently the filter unit and the arm can
be transported on a pallet in the original packing.
- To prevent damage, make sure that the filter unit and the
arm cannot shift on the pallet.
2

PRoDuCT DESCRiPTioN

2.1 Components
The product consists of the following main components and
elements:
Fig. 2.1
A shut-off damper
B extraction arm (shown: hose tube arm)
C control panel
D pre filter cassette
E HEPA filter cassette
F fan + motor
0000111659/150418/B MobileGo
5°C (41°F)
20°C (68°F)
70°C (158°F)
90%
no
A
Fig. 2.1 Main components and elements
2.2 operation
The MobileGo works in accordance with the recirculation
principle. Welding fume is extracted through the hood of the
connected extraction arm by the built-in fan. The polluted air
passes the pre filter cassette and is cleaned by the HEPA filter
cassette.
The cleaned air is returned in the workshop through the outlet
grid on the rear of the unit.
2.2.1 Indication of filter replacement
The MobileGo has a service indicator that monitors the airflow.
It gives an acoustic signal to replace the filter(s).
3

SaFETy iNSTRuCTioNS

General
The manufacturer does not accept any liability for damage to
the product or personal injury caused by ignoring of the safety
instructions in this manual, or by negligence during
installation, use, maintenance, and repair of the product
mentioned on the cover of this document and any
corresponding accessories.
Specific working conditions or used accessories may require
additional safety instructions. Immediately contact your
supplier if you detect a potential danger when using the
product.
The user of the product is always fully responsible for
observing the local safety instructions and regulations.
Observe all applicable safety instructions and
regulations.
user manual
- Everyone working on or with the product, must be familiar
with the contents of this manual and must strictly observe
the instructions therein. The management should instruct the
personnel in accordance with the manual and observe all
instructions and directions given.
- Do not change the order of the steps to perform.
- Keep the manual with the product.
B
C
D
E
F
EN - 4