BABYTREND JG95 Manual De Instrucciones página 4

ASSEMBLY
Remove stroller from box. The front wheel
and rear wheels MUST be installed prior to
use.
FRONT WHEELS
To attach the front wheels, unfold stroller as
described in the section following:
1) • Unlock the release lever (Fig. 1a).
Unfold stroller frame by pulling backward
on the stroller handle. Lean the stroller
backwards so that it rests on the handle
and rear axle frame and the front wheel
forks are pointing upward (Fig. 1b).
2) • Slide the front wheel onto the front forks
(Fig. 2).
3) • Slide the retainer plate onto the front
wheel. Be sure that the raised lip is
pointing toward the fork and insert it
into the slot on the fork. The tab on the
retainer plate must be lined up with the
slot before tightening the wheel (Fig. 3).
5
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 1a
Fig. 1b
Fig. 2
Front Fork Front Fork
Slot Slot
Axel and Axel and
Hub Hub
Axel Nut Axel Nut
Retainer Plate Retainer Plate
Fig. 3
4) • With the wheel in position, tighten the axel
nuts and tighten with standard crescent,
box, or open end wrench. You should
feel significant resistance and the wheel
should be held tightly in place (Fig. 4).
REAR WHEELS
5) • Rest the stroller upside down, on the
handle.
• Press the rear wheel posts into the rear
frame hub until it clicks into place (Fig. 5).
NOTE: Pull on the rear wheel to ensure
that it is securely attached to the stroller.
TIRES
6) • Tires are shipped un-inflated. The tires
should be inflated on a regular basis to
between 20 to 25 p.s.i. Always use a
bicycle style hand air pump to inflate the
tires. *Not included.
CUP HOLDER
WARNING:
To avoid
burns, never put hot liquids
in cup holder. Avoid possible
tipping, do not place more
than 1 lb. (0.45kg) in cup
holder.
7) • To attach cup holder: slide the clip on the
cupholder over Cup Holder tabs on the
Handle Bar. Push untill firmly in place
(Fig. 7).
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 4
Fig. 5
Fig. 7
6