Maintenance; Lamp Replacement - OPTIKA MICROSCOPES XZ-1 Manual De Istrucciones

5.0 MAInTenAnCe

5.1 electrical safety precautions
- Before plugging in the power cable with the supply, make sure that the supplying voltage of
your region matches with the operation voltage of the equipment and that the lamp switch is
in OFF-position.
- Do not turn the power on and off, off and on immediately as this will shorten the life span of
the bulb and may cause damage to the electrical system.
- Users should observe all safety regulations of the region. The equipment has acquired the
CE safety label. however, users do have full responsibility to use this equipment safely.
5.2 Always think about
- The following environment is required: Indoor temperature: 0-0°C, Maximum relative humi-
dity:  % (non condensing).
- Keep the microscope away from dust and shocks while in use.
- Turn off the light immediately after use.
- Use a soft lens tissue to clean the optics after use.
- Only if needed, use a cloth moistened with water and a mild detergent, rinsing with water and
drying immediately with a lint-free cloth.
- After use, cover the microscope with the included dust-cover, and keep it in a dry and clean
place.
5.3 do not!
- wipe the surface of any optical items with your hands. Fingerprints can damage the optics.
- Use solvents, neither on the microscope, nor on the optics.
- Disassemble objective or eyepieces to attempt to clean them.
- Mishandle or impose unnecessary force on the microscope.
- Clean the unit with volatile solvents or abrasive cleaners.
- Attempt to service the microscope yourself.
5.4

Lamp replacement

Before replacing a lamp, be sure that it is completed cooled.
Do not touch an halogen lamp with your bare hands, this could shorten the lifetime of the
bulb.
Page 10