Maintenance - OPTIKA MICROSCOPES B-500 Manual De Instrucciones

5.0 MAInTenAnCe

5.1 Always think about
- The following environment is required: Indoor temperature: 0-40°C, Maximum relative humi
dity:  % (non condensing).
- Keep the microscope away from dust and shocks while in use.
- Turn off the light immediately after use.
- Use a soft lens tissue to clean the optics after use.
- Only if needed, use a cloth moistened with water and a mild detergent, rinsing with water and
drying immediately with a lint-free cloth.
- After use, cover the microscope with the included dust-cover, and keep it in a dry and clean
place.
5.2 do not!
- Wipe the surface of any optical items with your hands. Fingerprints can damage the optics.
- Use solvents, neither on the microscope, nor on the optics.
- Disassemble objective or eyepieces to attempt to clean them.
- Mishandle or impose unnecessary force on the microscope.
- Clean the unit with volatile solvents or abrasive cleaners.
- Attempt to service the microscope yourself.
5.3 How to change the lamp
- Before changing the lamp, you must pull the plug out of the electrical socket. To avoid being
burnt, wait until the lamp has cooled down.
- Hold the main body and tilt the microscope until the bottom base can be seen. Loosen the
door-lock screw of the small door on the bottom base to open the lamp housing. The lamp
and lamp holder come out with the door.
- Pull out the old lamp. Hold the new lamp without touching it with your bare hands (e.g. using
its packaging, or a cloth) and insert it into the holder. Replace/close the lamp holder.
B-500 ERGO: the high-efficiency white LED source in B-500 ERGO is designed to last many
years without any performance decrease. Never try to replace it with another kind of LED
source. In case of malfunctioning contact OPTIKA service.
5.4 If you need to send the microscope to Optika for maintenance, please use the original
packaging.
Page 10