Hardware Setup And Connections - GENDEX DenOptix QST Manual Del Usuario Y De Servicio

Figure 4-14
Power Cord, 1 each
4.10

Hardware setup and connections

NOTE: Before you start the hardware setup, ensure that you have an acceptable com-
puter as outlined in Section 4.4. The computer must have a USB 2.0 port available.
Step 1: Pick a location using the guidelines from Section 4.8.
Step 2: Set up the computer and monitor per the manufacturer's recommendations. Use an
Step 3: Turn the power on to the monitor and computer.
Step 4: Connect the device end of the USB 2.0
Step 5: Connect the computer to a network
Step 6: Turn the power on the scanner. The green light on the scanner should be lit at this
Step 7: After the Windows operating system is loaded, a message indicating that a "New
User and Service Manual
ergonomic setup to minimize repetitive motion injuries.
cable to the USB 2.0 connector on the
back of the DenOptix QST scanner.
Connect the scanner to a grounded
power outlet. Make sure the other end
of the USB 2.0 cable is connected to the
USB 2.0 port on the computer.
if desired. Refer to your Imaging
Software User Manual and Installation
Guide for more information on how to
configure the Imaging Software in a
network.
time. If it is not, follow the trouble shooting guidelines in Section 7.3.
Hardware" has been found will appear. Follow the on-screen instructions to final-
ize the installation.
Figure 4-15
User Manual and
Installation Guide
(Software and Hardware),
1 each
24
Gendex DenOptix® QST
Figure 4-16
USB 2.0 cable (6 ft, 2 m)
1 each
Doc # M010-004WWE July 2005