BABYTREND JG57 Manual De Instrucciones página 4

ASSEMBLY
3) • Slide the retainer plate onto the front
wheel. Be sure that the raised lip is
pointing toward the fork and insert it
into the slot on the fork. The tab on the
retainer plate must be lined up with the
slot before tightening the wheel (Fig. 3).
4) • With the wheel in position, tighten the
axel nuts and tighten with standard
crescent, box, or open end wrench. You
should feel significant resistance and
the wheel should be held tightly in place
(Fig. 4).
REAR WHEELS
5) • Rest the stroller upside down, on the
handle.
• Press the rear wheel posts into the rear
frame hub until it clicks into place (Fig. 5).
NOTE: Pull on the rear wheel to ensure
that it is securely attached to the stroller.
TIRES
6) • Tires are shipped un-inflated. The tires
should be inflated on a regular basis to
between 20 to 25 p.s.i. Always use a
bicycle style hand air pump to inflate the
tires (Fig. 6). *not included
5
Copyright © 2015, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Front Fork
Slot
Axel and Hub
Retainer Plate
Axel Nut
Fig. 3
Fig. 4
Fig. 5
Fig. 6
PARENT TRAY
WARNING:
Do not
place hot liquids or more than
3 pounds in the parent tray.
Serious burns or unstable
conditions could result.
7) • To attach parent tray: align the fittings
on the ends of the parent tray with the
fittings on the outsides of the handle. Pull
outward on the opposite end of the tray
while pushing down until the tray locks
onto the stroller handle (Fig. 7).
Check to make sure the parent tray is
secure before using.
CANOPY
8) • To open the canopy: push forward
on the front edge of the canopy while
holding the rear of canopy in place
(Fig. 8).
• To fold the canopy: pull backwards on
the front edge (Fig. 8).
SEATBACK POSITIONING
9) • To recline the seat: loosen the strap
through the buckle and adjust to the
required recline position (Fig. 9a). To
place the seat back in a more upright
position, press upward on the seat back
with one hand while pulling the strap
through the buckle with the other (Fig. 9b).
Note: The upright position should be
used only for a child that is at least 6
months old. Always re-adjust the safety
harness, including the shoulder belts,
when repositioning the seatback.
Copyright © 2015, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
Fig. 7
Note:
Fig. 8
Fig. 9a
Fig. 9b
6