Kohler K-108 Guia De Instalacion página 5

Spout Shank
Rubber Washer
Plastic Gasket
Tee Hex-End
Guide Tube Nut
3. Supply Tee Installation
From the underside of the lavatory, thread the shank nut about
halfway up onto the spout shank. Slide the metal washer onto the
spout shank.
Insert the plastic gasket and the rubber washer into the supply
tee.
Slide the metal washer onto the spout shank.
Thread the supply tee onto the spout shank until hand tight.
Ensure that the arms of the supply tee are aligned to face the left
and right sides of the lavatory.
Tighten the hex end of the supply tee with a wrench. Do not
overtighten.
Slide the metal washer down to the supply tee and thread the
shank nut down to the metal washer. Securely tighten with a
wrench. Do not overtighten.
Slide the O-ring over the guide tube and securely tighten the nut
to the supply tee sleeve with a wrench. Do not overtighten.
Slide the O-ring all the way up the lift rod.
Securely hand tighten the nut on the lift rod until a desired
resistance is achieved.
Kohler Co.
Shank Nut
Metal Washer
Guide Tube
Supply Tee
Supply Inlet
O-Ring
5 1010441-2-B