Fan Assembly. Pgs - Craftmade BW321AG3 Guia De Instalacion

Ocultar thumbs Ver también para BW321AG3:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5. Fan Assembly.
If you wish to extend the hanging length of
your fan, you must remove the hanging ball
from the 4½in. downrod provided to use with
an extended downrod (sold separately). [If you
wish to use the 4½in. downrod, please proceed to
instructions following the dotted line below.]
To remove hanging ball, loosen set screw on
hanging ball, lower hanging ball and remove
stop pin. Slide hanging ball off the original
downrod, A, and slide it down the longer
downrod, B (the top of the downrod should be
noted as having a set screw hole; use this hole
when setting the set screw). Insert stop pin into
top of extended downrod and raise hanging
ball. Be sure stop pin aligns with slots on the
inside of the hanging ball. Tighten set screw
securely.
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of
electrical tape to the ends of the electrical
wires--this will keep the wires together when
threading them through the downrod.
Locate canopy cover in hardware pack. [Note: If
canopy cover is pre-attached to canopy, remove
by turning canopy cover counterclockwise.]
Loosen yoke set screws and nuts in yoke at top
of motor assembly and remove pin and clip
from yoke. Slide downrod through canopy,
canopy cover* and yoke cover.
*NOTE: Canopy cover must be turned with
shiny side toward the motor assembly.
Thread safety cable and electrical wires through
downrod and pull extra wire slack from the
upper end of the downrod.
Thread downrod into yoke in motor assembly
until holes for pin and clip in downrod align
with holes in yoke--make sure wires do not get
twisted. Securely tighten yoke set screws and
nuts. Lower yoke cover to motor assembly.
NOTE: The important safety precautions and
instructions appearing in the manual are not
meant to cover all possible conditions and
situations that may occur. It must be understood
that common sense and caution are necessary
factors in the installation and operation of this
fan.
set screw
A
electrical wiring
downrod
canopy
yoke cover
clip
page 4
set screw hole
stop pin
hanging ball
B
safety cable
canopy cover
yoke set screw
and nut
pin
motor
assembly

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Bw321ss3

Tabla de contenido