Remote Control Operation; Testing Your Fan - Craftmade BW321AG3 Guia De Instalacion

10. Remote Control Operation.

HI button - turns lower fan to HIGH speed
MED button - turns lower fan to MEDIUM speed
LOW button - turns lower fan to LOW speed
OFF button - turns lower fan OFF
button - turns main fan ON/OFF when pressed
once (i.e., controls ROTATION of the
ENTIRE fan)

11. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Locate ON/OFF
slider switch on wall control and set to the ON
position. Test ROTATION/OFF function of fan with
button used to control rotation of fan; test fan
speeds of fan with different fan speed buttons and
OFF button. Next, locate remote control. Test fan
speeds (and OFF) with the different fan speed
buttons and then test rotation of fan (and OFF) as
was done with wall control. If the remote control
operates all of the functions of the fan, battery has
been installed correctly. If the wall and/or remote
control(s) do (does) not operate all of the fan
functions, refer to "Troubleshooting" section to
solve any issues before contacting Customer
Service.
NOTE: If remote control interferes with other
appliances, change code switches on remote
control transmitter and wall control to another
code. If you do change the code, turn power off
first, remove the battery cover, and, after setting the
new code in transmitter (AND wall control), go back
to the instructions in the last paragraph of Section 8
(page 7).
The tilt angle of the fan may be adjusted up or
down by simply moving the fan motor gently up or
down. CAUTION: To avoid personal injury or
damage to the fan, fan MUST BE TURNED OFF
before adjusting the tilt angle.
page 8
main
fan
lower fan
motor