Canopy Assembly - Craftmade BW321AG3 Guia De Instalacion

6. Wiring. (cont.)
IN ORDER TO WIRE WALL CONTROL, remove
existing wall switch. Wire the WALL CONTROL
with wire connectors provided as shown in
diagram at right.
* Wrap each wire connector separately with
electrical tape as an extra safety measure. Gently
push wires and taped wire connectors into outlet
box.
Use a ballpoint pen or a small screwdriver to set
the code switches 1 through 4 on the wall control.
Factory setting is pre-set and not recommended
for use. Write down number sequence for use in
Section 8.
Attach wall control to outlet box and secure with
screws from original wall switch. Attach front plate
to wall control using 2 screws provided in the wall
control.
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

7. Canopy Assembly.

Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded
part of slotted hole in canopy over loosened
screw in hanging bracket and push up. Twist
canopy to lock. Re-insert screw that was removed
and then tighten both screws securely. Slide
canopy cover up to canopy, aligning rounded part
of slotted holes in canopy cover with screwheads
in bottom of canopy. Turn canopy cover to the
right (clockwise) until it stops.
*Remember that antenna for remote control
receiver must rest outside of hanging bracket.
outlet box
(wiring for wall control)
radio
radio or television
screw
canopy
page 6
wall
control
green/
green/ green/
bare
bare bare
ground
ground ground
green
black (OUT to fan)
black
black
(TO POWER supply)
black
(AC IN from
breaker box)
antenna
hanging bracket
screw
canopy cover
plate
code
switches