Automated Learning Process/Activating Code; Wall Control Operation - Craftmade BW321AG3 Guia De Instalacion

Ocultar thumbs Ver también para BW321AG3:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

8. Automated Learning Process./
Activating Code.
CAUTION: The remote control transmitter can be
programmed to multiple receivers or fans. If this is
not desired, turn wall switch off to any other
programmable receiver or fan.
Remove battery cover from back side of remote
control transmitter.
Use a ballpoint pen or a small screwdriver to set
the code switches 1 through 4 for the transmitter.
Use the same number sequence used when wiring
the wall control in Section 6 (page 6).
Install 9-volt battery (included) in transmitter.
Re-attach the battery cover after installing battery.
IMPORTANT: To prevent damage to transmitter,
remove the battery if not used for long periods.
Restore electrical power and then set slider switch
on wall control to the ON position. Within 30
seconds of turning on the wall control, press and
hold the "OFF" button on the front of the
transmitter for 5 seconds. Proceed to Section 11 to
verify that the automated learning process is
complete.

9. Wall Control Operation.

ON/OFF slider switch - turns wall control ON or OFF
HI button - turns lower fan to HIGH speed
MED button - turns lower fan to MEDIUM speed
LOW button - turns lower fan to LOW speed
FAN OFF button - turns lower fan OFF
button - turns main fan ON/OFF when pressed
once (i.e., controls ROTATION of the
ENTIRE fan)
TRANSMITTER
page 7
code
pen
switches
(back)
battery
battery
cover
TRANSMITTER
(front)
main
fan
lower fan

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Bw321ss3

Tabla de contenido