Char-Broil Professional Serie Instrucciones De Funcionamiento página 4

WARNING
Turn controls and gas cylinder off when not in
CAUTION
If ignition does NOT occur in 5 seconds, turn
the burner controls off, wait 5 minutes and
repeat the lighting procedure. If the burner
does not ignite with the valve open, gas will
continue to flow out of the burner and could
accidently ignite with risk of injury.
Match-Lighting
• Do not lean over barbecue while lighting.
1. Turn gas burner control valves to (off).
2. Open lid during lighting or re-lighting.
3. Turn ON gas at LP cylinder.
4. Place match into match holder (hanging from
side panel of barbecue). Light match; then light
burner by placing match through the match light
hole on side of barbecue. Immediately push in
and turn burner knob to the
Be sure burner lights and stays lit.
5. Light adjacent burners in sequence by pushing
knobs in and
Cleaning the Burner Assembly
Follow these instructions to clean and/or replace
parts of burner assembly or if you have trouble
igniting barbecue.
1. Turn gas off at control knobs and LP cylinder.
2. Remove cooking grates and heat tents.
3. Remove carryover tubes and hardware securing
burners.
4. Detach electrode from burner.
use.
HIGH position.
Leak Testing Valves, Hose and
Regulator
Leak test before first use, at least once a year, and
every time the cylinder is changed or
disconnected.
1. Turn all appliance control knobs to .
2. Be sure regulator is tightly connected to gas
cylinder.
3. Turn on Gas. If you hear a rushing sound, turn
gas off immediately. There is a major leak at the
connection. Correct before proceeding.
4. Brush soapy solution (mixture of half soap and
half water) onto hose connections.
5. If growing bubbles appear, there is a leak. Turn
off gas at cylinder immediately and check
tightness of connections. If leak cannot be
stopped do not try to repair. Call for
replacement parts.
6. Always turn off gas at cylinder after performing
leak test.
IF APPLIANCE FAILS TO LIGHT

Make sure gas is turned on at cylinder.

Make sure there is gas in the cylinder.

Does the ignitor make a sparking noise?
If yes check for spark at burner.
If no spark check for damaged or loose wires.

If wires are OK check for cracked or broken
electrode, replace if needed.

If wire or electrodes are covered by cooking
residue, clean electrode tip with alcohol wipe if
needed.

If needed replace wires.

If no sound check battery.

Make sure battery is installed correctly.

Check for loose wire connection at module and
switch.
use match.
NOTE: Removal/Detachment method will depend
on the burner configuration. See different
configurations in illustrations below.
5. Carefully lift each burner up and away from valve
openings.We suggest three ways to clean the
burner tubes. Use the one easiest for you.
A. Bend a stiff wire (a light weight coat hanger
works well) into a small hook. Run the hook
through each burner tube several times.
4 GB

If ignitor continues to not work then