Special Accessories; Technical Data - Hansgrohe Metropol S 14061 Serie Manual De Montaje

Important! The fitting must be installed, flushed and
tested after the valid norms.
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in posi-
tion on the basin / bidet.
3. Slip the slide washer, washer and collar nut over the
hose and threaded base and tighten the collar nut
by hand.
4. Tighten screws.
5. Connect the supply pipes to the isolation valves;
cold right - hot left.
6. Connect the pull rod to the pop-up waste.
The hot and cold supplies must be of equal pressures.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.

Technical Data

This mixer series-produced with EcoSmart®
(flow limiter).
Rate of flow with EcoSmart:
Rate of flow without EcoSmart:
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Hansgrohe single lever mixers can be used together with
hydraulically and thermically controlled continuous flow
heaters if the flow pressure is at least 0,15 MPa.
If the continuous water heater causes any problems or
there is not enough flow of water, the EcoSmart® (6a)
located behind the aerator must be removed.
To adjust the hot water limiter on single lever mixers, please
see page 38.
No adjustment is necessary when using a continuous flow
water heater.
English
7 l/min 0,3 MPa
14 l/min 0,3 MPa
max. 1 MPa
0,1 - 0,5 MPa
1,6 MPa
max. 80° C
65° C
Spare parts (see page 4)
1 handle
2 flange
3 nut
4 cartridge cpl.
5 seal
6 aerator cpl.
7 aerator cpl.
8 fixing set
9 pull rod
10 ball joint
11 connection hose
connection hose
12
13 screw cover

Special accessories

X special tool set
(order as an extra)
XXX = Colors
000 = chrome plated
880 = satin chrome
14895XXX
97406XXX
97209000
92730000
95008000
13912000
97360XXX
13961000
96657XXX
97362XXX
96321000
97206000
96338000
58085000