Denver CRP-618 Manual De Instrucciones página 7

NOTE : PROJECTS TIME IMAGE ON THE CEILING OR WALL OF A
DARKENED ROOM.
MAXIMUN PROJECTION DISTANCE IS 3-9 FEET.
Specifications
- Frequency range : 87.5 – 108MHz
- Battery backup : 3V (CR2032 Flat Lithium battery x 1) not included
- Power supply : AC230V ~ 50Hz
Resetting
If the system does not respond or exhibits erratic or intermittent
operation, you may have experienced an electrostatic discharge (ESD)
or a power surge that triggered the internal microcontroller to shut
down automatically. If this occurs, simply disconnect the ac power
cord and remove the system backup battery, wait for at least 3 minutes
and then setup the unit again as if it is a brand new unit.
1. No naked flame sources, such as lighted candles, should be
placed on the apparatus.
2. Do not place the product in closed bookcases or racks without
proper ventilation.
3. The mains plug is used as the disconnect device, the disconnect
device shall remain readily operable.
4. The ventilation should not be impeded by covering the ventilation
openings with items, such as newspapers, table-cloths, curtains,
etc.
5. It shall not be exposed to dripping or splashing and that no objects
filled with liquids, such as vases, shall be placed on the apparatus.
6. Do not connect FM antenna to outside antenna.
7. The unit should not be exposed to direct sunlight, very high or low
temperature, moisture, vibrations or placed in dusty environment.
8. Do not use abrasive, benzene, thinner or other solvents to
clean the surface of the unit. To clean, wipe it will mild non-
abrasive detergent solution and clean soft cloth.
9. Never attempt to insert wires, pins or other such objects into the
vents or opening of the unit.
10. Batteries shall not be exposed to excessive heat such as sunshine,
fire or the like.
WARNING
ENG-6