Bottom Rack Loading - Kenmore Ultra Wash 665.1454 Manual De Uso Y Cuidado

5. Replace the track stops by coming up from under the track and slipping the lower tab of the track
stop into the lower slot of the track (see Track stop - right) and rotate the track stop into place.
Then press on the edge of the ridged area while pushing the track stop straight toward the track.
This action locks the retaining tab back into place.
6. Test the track stop by pulling it toward the opposite track to ensure that it is locked in place.
To replace the rack:
1. Gently pull the tracks forward in dishwasher until they stop. Remove track stops. See steps
1-3 above.
2. Place the back wheels on each side of the rack into the track and roll the rack into the tracks,
but do not push the rack all the way into the tub.
3. Insert front rack wheels on each side of the rack into the track.
4. Slide the rack into the dishwasher.
5. Replace the track stops. See steps 5 and 6 above.
IMPORTANT: Be sure that the track stops are locked in place and cannot be easily removed.
They keep the rack from coming out of the track.
Loading Recommendations
The bottom rack is best suited for plates, pans, casseroles, and utensils. (See recommended loading patterns shown.)
Load small items in the bottom rack only if they are secured in place.
Load plates, soup bowls, etc., between tines.
Load bowls securely between the rows of tines. Ensure that there is space between dishes so that the spray will reach all surfaces.
Load heavily soiled items facing the spray.
NOTE: Ensure that detergent dispenser is not blocked by tall items such as cookie sheets and cutting boards.
Loading Tall Items
You can wash larger items such as pots, roasters, and cookie
sheets in the bottom rack by removing the top rack. See the
"Top Rack Loading" section.

Bottom Rack Loading

10-place load
Track stop - right
12-place load
13