LG SIGNATURE WM9500HA Serie El Manual Del Propietario página 45

Ocultar thumbs Ver también para SIGNATURE WM9500HA Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Problem
Power cord is not properly
plugged in.
Washer will not turn
House fuse is blown, circuit
on
breaker has tripped, or power
outage has occurred.
The washer automatically adjusts
Wash cycle time is
the wash time for the amount of
longer than usual
laundry, water pressure and other
operating conditions.
Bleach dispenser cover is not
properly installed.
Bleach does not
dispense
Bleach dispenser is dirty or
clogged.
Premature dispensing
Bleach dispenser filled for future
of bleach
load.
Detergent compartments clogged
from incorrect filling.
Incomplete or
Too much detergent used.
no dispensing of
detergent
Insufficient water supply.
Normal residue.
Possible Cause
TROUBLESHOOTING
Solutions
• Make sure that the plug is plugged securely into
a grounded, 3-prong, 120-VAC, 60 Hz outlet.
• Reset circuit breaker or replace fuse. Do not
increase fuse capacity. If the problem is a
circuit overload, have it corrected by a qualified
electrician.
• This is normal. The washer adjusts cycle time
automatically to provide optimal results for the
selected cycle. The time remaining shown in the
display is only an estimate. Actual time may vary.
• Make sure that the bleach cover is properly
installed and snapped into place before the
beginning of the cycle.
• Lift out the bleach dispenser cover and clean out
the reservoir. Lint and other foreign debris that
collects in the inside the dispenser may prevent
proper dispensing of the bleach.
• You cannot store bleach in the dispenser for
future use. The bleach will be dispensed every
load.
• Make sure that detergent and additives are put
into the correct dispenser compartments. For
all detergent types, always make sure that the
dispenser drawer is fully closed before the start
of the cycle.
• Make sure that the suggested amount of
detergent is used per the manufacturer's
recommendations. You may also dilute the
detergent with water to the maximum fill line on
the compartment to avoid clogging. Use only HE
(High-Efficiency) detergent.
• NOTE: Always use as little detergent as
possible. High-Efficiency washers need very little
detergent to achieve optimum results. Using too
much detergent will cause poor wash and rinse
performance and may contribute to odors in
washer.
• Make sure that both hot and cold water faucets
are turned on all the way.
• It is normal for a small amount of detergent to
remain in the dispenser. If this residue builds
up it can interfere with normal dispensing of
products. Refer to the cleaning instructions.
45

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido