Eaton IRIS PN4LED Instrucciones De Instalación página 5

N Noee: If top access for LED module replacement is
required, the two locking screws that hold the LED
module (Figure 15.) must be removed prior to
installation of the housing platform into the ceiling.
1. Access the internal components of the housing by
lifting open or removing the top cover.
2. Disengage the LED module from the collar using the
two module springs. Using a flat head screwdriver
will help to disengage the module springs from their
engagement slots (Figure 14.).
3. Remove the LED module from the collar.
4. Loosen two thumb screws and disconnect two
electrical connectors to remove driver (if necessary).
5. Replace driver by re-installing two electrical connectors
and tightening two thumb screws.
6. Reinstall LED module. Close top cover and secure
using the access screw.
N Noee: When removing the driver through the aperture, the
power wires may need to be removed from under
the wire holder on the side of the housing in order
for the ballast module to be completely accessed
through the aperture.
Module Springs
Figure 14.
Figure 15.
Installation Instructions – PN4LED Recessed Housing Platforms
Module Springs
Locking Screw
LED MODULE / DRIVER REPLACEMENT THROUGH
APERTURE
The LED module can be removed through the aperture for
servicing and for instances where the orientation of the
LED module needs to be changed. The LED module must
be removed in order to access the driver assembly and
junction box through the aperture.
1. Remove the two locking screws that hold the LED
module in place to the collar. (Figure 17 .)
2. Disengage the LED module from the collar using the
two module springs.(Figure 18.)
3. Disconnect the quick-connect of the LED module from
the housing.
4. Remove Led module through aperture.
Figure 16.
Figure 17.
Figure 18.
EATON IB520001EN
Installation instructions
5