Eaton IRIS PN4LED Instrucciones De Instalación página 6

Installation Instructions – PN4LED Recessed Housing Platforms
The LED module can now be serviced. For driver servicing,
please see the appropriate section. To reinstall the LED
module:
1. Connect the quick-connect of the module to the
housing quick-connect.
2. Place the LED module through the aperture.
3. Using the hook on the legs of the LED module, engage
the module with the corner slots of the collar.
(Figure 19.)
4. Engage the module springs into the slots on the collar.
Make sure the LED module is securely attached.
5. Attach the locking screws into the module springs to
lock the LED module in place.
Figure 19.
6
EATON IB520001EN
Leg Hook
Installation instructions
Driver Servicing through aperture
The LED module must be removed before servicing the
driver module.
1. Remove the LED module per the instructions in the
'LED Module Servicing' section
2. Loosen the thumbscrews used to secure the driver
module in place. The thumbscrews are captive, but do
not over-loosen as the captive clips may be damaged.
3. Remove the driver module by sliding upwards until it
clears the thumbscrews. (Figure 20.)
N Noee: When removing the driver module through the
aperture, the power wires may need to be removed
from under the wire holder on the side of the
housing in order for the driver module to be
completely accessed through the aperture.
4. Reinstall the driver module into the housing, and lock
the position using the captive thumbscrews.
Driver
Thumb Screw
Figure 20.
Driver Door
Assembly (Lutron
Driver shown)