Operating Instructions; Airc Onditioner - Carrier KC_141P Instrucciones De Instalación Y Funcionamiento

OPERATING INSTRUCTIONS

Electronic Control Panel Model
You can easily operate this air conditioner by pressing relevant
button on the control panel as well as the remote control
|
Button
The air conditioner will be started when it is energized or will be
stopped when it is in operation, if you press this button. When the
air conditioner is heating, allow 3 minutes after you press this
button.
Mode Button
Each time MODE button is pressed, the operation mode is changed
in sequence:
COOL: COOLING - - FAN ONLY - - ENERGY SAVING - -
COOLING
HEAT: COOLING - - FAN ONLY - - HEATING - -
ENERGY SAVING - - COOLING
NOTE: After setting the mode, allow 3 minutes before switching
to another mode.
In the FAN ONLY Mode, room temperature display range is from
0_C (32_F) to 38_C (99_F).
Room temperature below 32_F, the temperature display L0.
Room temperature above 99_F, the temperature display H1.
Fan Speed Button
Used to select fan speed in sequence auto, low, medium, and high.
Timer Button
Used to set or cancel timer operation.
When the unit is in operation, you can set OFF TIMER.
When the unit is off, you can set ON TIMER.
Timer setting range is 0 to 24 hours.
If the OFF TIMER is set, the timer LED displays the remaining
time to turn off the unit for only 12 seconds, then LED shifts to
display set temperature. If you press TiMER button within the 12
seconds, OFF TIMER will be canceled.
If the ON TIMER is set, the timer LED displays the remaining time
to turn on the unit. If you want to cancel ON TIMER, press
TIMER button.
Button
Used to set room temperature in COOLING mode or used to set
time in TIMER mode. If the two keys are pressed at the same time,
the temperature LED display will alternate between _C and _F.
NOTE: Temperature setting range is from 19_C (66_F) to
31_C (88_F).
Tim er
Fa n
Mode
Spe e d
Indication symbols of LED on control panel:
Auto fan speed
Low fan speed
Medium fan speed
High fan speed
Above LED lights on when the relevant mode is in used.
Fig. 28 --- Control Panel
12

Airc onditioner

Cooling
F
h
Fan only
Display set temp
Display set timer
Heating
Energy-saving
Timer