Revell Control ROXTER Manual De Instrucciones página 10

3 INSERTING BATTERIES (REMOTE CONTROL)
3A Unscrew and remove the cover.
3B Insert 4 x 1.5 V AA batteries and pay attention to the polarity,
as shown in the battery compartment.
3C Close the battery cover and secure with the screw.
4 CHARGING THE HELICOPTER
Attention: The battery must cool down for 10 to 15 minutes before
charging and after every flight. Failure to do so may result in the
battery becoming damaged. The charging process is electronically
monitored, but do not leave it unsupervised.
• Switch off the helicopter and the remote control.
• Carefully place the helicopter with the fuselage facing upwards on the
remote control. In the process, make sure that the circuit board
contacts are guided into the slot on the remote control (4A).
• ‚The charging process begins when the blue charge LED in the
helicopter illuminates (4B).
• The charging process has been completed when the USB plug lights up.
• Remove the helicopter from the remote control after the charging
process.
After a charging time of 20­30 minutes, the helicopter can fly
for approx. 5­7 minutes.
5 START PREPARATION
The thrust controller (the left controller on the remote control) must
point down before being switched on (5A). Then briefly press the
ON/OFF button on the remote control (5B) and the Power LED blinks
red. Now set the ON/OFF switch on the underside of the helicopter to
Place the helicopter on the ground so that
the „ON" position (5C).
its tail points toward you.
Then briefly apply full throttle with the left
joystick, after which the Power LED on the remote control illuminates
permanently red. Now the helicopter is ready to start. After the flight,
first switch off the helicopter, then the remote control. Press and hold
the ON/OFF button on the remote control for approximately 3 seconds
to switch it off.
18
6 TRIM ADJUSTMENT OF THE CONTROL
The correct trimming is a basic requirement for achieving fault-free
flying from the helicopter.
6A
If the helicopter
automatically rotates
clockwise...
If the helicopter begins to
automatically rotate clockwise
quickly or slowly, briefly tap the
anti-clockwise counter-rotation
trim adjustment until the
helicopter no longer rotates
automatically. Do not simply
actuate the trim buttons
continuously.
7 FLIGHT CONTROL
Note: Your helicopter is to fly forwards.
7A In order to start or gain
altitude, carefully move the
thrust control forward.
7C To fly along a left-handed
curve, carefully move the
directional controller to the left,
as long as the helicopter tail is
facing toward the pilot.
6B
If the helicopter
automatically rotates
anti­clockwise ...
If the helicopter begins
to automatically rotate
anti-clockwise quickly
or slowly, briefly tap the
clockwise counter-rotation trim
adjustment until the helicopter
no longer rotates automatically.
Do not simply actuate the trim
buttons continuously.
7B Move the thrust control
back for landing or to fly lower.
Only minimal corrections to
the controller are necessary to
ensure smoothing flying of the
helicopter!
7D To fly along a right-handed
curve, carefully move the
directional controller to the
right, as long as the helicopter
tail is facing toward the pilot.
19