Reversing Door Swing
Reassembling the door
1. Lift the inner glass ring. Rotate it 180 degrees, reinstall
on outer door, lining up indicators - "LH" for left-hand
hinge or "RH" for right-hand hinge.
2. Rest the opening of the inner door at a 90 degree
angle on the supports for the hinge cutout cover. Pivot
the inner door down onto the outer door.
3. Replace indented head screws (no. 1-5) removed earlier.
Take care not to strip out the plastic holes.
4. Replace pan head screws (no. 6-7) removed earlier.
Take care not to strip out the plastic holes.
no. 1-5
5. Locate new metal strike supplied with dryer manuals.
Grip new strike with pliers as shown below. Firmly insert
the strike so it is oriented vertically.
22
no. 6-7