Hilti WSR 900-PE Manual De Instrucciones página 11

▶ Secure the workpiece in a sturdy holder. Never hold the workpiece with your hand or across your leg.
▶ Switch the product on only after bringing it to the working position.
▶ When working with the product, always guide it away from your body.
▶ Apply only moderate pressure and cut at an appropriate speed, especially when cutting large-diameter
pipes. This will help to prevent the product overheating.
▶ Before cutting through pipes, make sure that they are empty of medium. Drain the pipes if necessary.
▶ When cutting through pipes, hold the product above the level of the pipe you are cutting through. The
product is not protected against ingress of moisture. Liquid running out of a pipe can cause a short
circuit in the product.
▶ Never cut into unknown materials and make sure the path of the saw is free of obstructions above and
below the workpiece. The product can kick back if the saw blade comes into contact with an obstructing
object.
▶ Wear protective gloves also when changing the accessory tool. Touching the accessory tool presents a
risk of injury (cuts or burns).
▶ Comply with the manufacturer's instructions for handling and storing saw blades.
▶ The user and persons in the vicinity must wear suitable protective goggles, a hard hat, ear defenders,
protective gloves and light respiratory protection while the product is in use.
▶ Never use the product without the hand guard correctly installed. Do not use the cover over the blade
holder / chuck as a gripping area. The blade holder /chuck presents a risk of injury.
▶ The product must be pressed against the workpiece until the contact shoe makes firm contact. This
ensures optimum and safe progress as you work.
▶ Always use saw blades that project at least 40 mm beyond the workpiece over the entire length of the
blade stroke. This can help to avoid violent kickback.
3 Description
3.1 Overview of the product
3.2 Intended use
The product described is a reciprocating saw. It is designed for cutting wood, wood-like materials, metals
and plastics.
The product is designed for two-handed operation.
*376750*
1
376750
Blade holder
@
Orbital action selector switch
;
Stroke rate regulator
=
Safety lock
%
Control switch
&
Rating plate
(
Motor
)
Gearing section
+
Forward gripping area (hand guard)
§
Hand guard
/
Contact shoe adjustment button
:
Contact shoe
∙
Saw blade
$
English 5