Manufacturer's Warranty; Notice D'utilisation Originale; Indications Relatives À La Documentation - Hilti WSR 900-PE Manual De Instrucciones

7 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
7.1 Troubleshooting
Trouble or fault
The tool will not start.
The power tool does not
achieve full power.
The saw blade cannot be
removed from the chuck.
Orbital-action function does
not react
Contact shoe or pipe-cutting
adapter cannot be removed
8 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
9

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.

Notice d'utilisation originale

1 Indications relatives à la documentation
1.1 À propos de cette documentation
• Lire intégralement la présente documentation avant la mise en service. C'est la condition préalablement
requise pour assurer la sécurité du travail et un maniement sans perturbations.
• Bien respecter les consignes de sécurité et les avertissements de la présente documentation ainsi que
celles figurant sur le produit.
*376750*
Possible cause
Interruption in the electric supply
The supply cord or plug is defec-
tive.
The control switch is defective.
The extension cord is too long
and/or its gauge is inadequate.
The control switch is not fully
pressed.
The locking sleeve is not turned as
far as it will go.
Orbital-action switch is not in the
position for orbital action.
Prevented by saw blade.
Pushbutton not pressed in all the
way.
376750
Action to be taken
▶ Plug in another power tool or
appliance and check whether it
works.
▶ Have the tool repaired only by a
Hilti Service Center.
▶ Have the tool repaired only by a
Hilti Service Center.
▶ Use only extension cords
of a type approved for the
application and with conductors
of adequate gauge.
▶ Press the control switch fully.
▶ Turn the locking sleeve as far as
it will go and remove the saw
blade.
▶ Move the orbital-action switch
to the position for orbital action.
Orbital action is perceptible only
when the saw is cutting.
▶ Remove the saw blade and then
remove the contact shoe.
▶ Press the pushbutton all the
way in and remove the saw
blade.
Français 9