Maintenance And Service; Maintenance And Cleaning - stayer TM6B Manual De Instrucciones

Dust/Chip Extraction
f Dusts from materials such as lead-containing
coatings, some wood types, minerals and
metal can be harmful to one's health. Touch-
ing or breathing-in the dusts can cause aller-
gic reactions and/or lead to respiratory infec-
tions of the user or bystanders.
Certain dusts, such as oak or beech dust, are
considered as carcino genic, especially in
connection with wood-treatment additives
(chromate, wood preservative). Materials
containing asbestos may only be worked by
specialists.
– Provide for good ventilation of the work-
ing place.
– It is recommended to wear a P2 filter-
class respirator.
Observe the relevant regulations in your
country for the materials to be worked.
Operation
Starting Operation
f Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V
can also be operated with 220 V.
Reversing the Rotational Direction
(see figure C)
The rotational direction switch 7 is used to re-
verse the rotational direction of the machine.
However, this is not possible with the On/Off
switch 6 actuated.
Right Rotation: For drilling and driving in
screws, push the rotational direction switch 7
left to the stop.
Left Rotation: For loosening and unscrewing
screws and nuts, press th e rotational direction
switch 7 through to the right stop.
Switching On and Off
To start the machine, press the On/Off switch 6
and keep it pressed.
To lock the pressed On/Off switch 6, press the
lock-on button 5.
ENGLISH
8
To switch off the machine, release the On/Off
switch 6 or when it is locked with the lock-on
button 5, briefly press the On/Off switch 6 and
then release it.
Adjusting the Speed
The speed of the switched on power tool can be
variably adjusted, depending on how far the
On/Off switch 6 is pressed.
Light pressure on the On/Off switch 6 results in
a low rotational speed. Further pressure on the
switch results in an increase in speed.
Working Advice
f Apply the power tool to the screw/nut only
when it is switched off. Rotating tool inserts
can slip off.
For drilling in metal, use only perfectly sharp-
ened HSS drill bits (HSS=high-speed steel). The
appropriate quality is guaranteed by the Stayer
accessories program.

Maintenance and Service

Maintenance and Cleaning

f Before any work on the machine itself, pull
the mains plug.
f For safe and proper working, always keep
the machine and ventilation slots clean.
If the replacement of the supply cord is neces-
sary, this has to be done by Stayer or an author-
ized Stayer service agent in order to avoid a safe-
ty hazard.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Stayer power tools.
Noise/Vibration Information
P Power
1
n Rotation speed
0
D Chuck clamping range
max
a Typically rated acceleration in the hand-arm area
h
L Acoustic pressure level
pA
L Acoustic power level
WA
m Mass
8