Illustrated Description; Placement And Testing - stayer ROCKY L20 Manual De Instrucciones

LED
Continuous lighting, green
Continuous lighting, red
Temperature Dependent Overload Protection
When using as intended for, the power tool cannot be
subject to overload. When the load is too high or the
allowable battery temperature of 70 °C is exceeded,
the electronic control switches off the power tool until
the temperature is in the optimum temperature range
again.
Additionally, the battery charge-control indicator 5
flashes green and red at the same time until the On/
Off switch 9 is released.

ILLUSTRATED DESCRIPTION

1 SDS-PLUS tool holder
2 Dust protection cap
3 Locking sleeve
4 Selector switch for drilling/hammer drilling
5 Battery charge-control indicator
6 Indicator for right rotation*
7 Indicator for left rotation*
8 Rotational direction switch
9 On/Off switch
10 Universal bit holder*
11 Screwdriver bit*
12 Screwdriver bit with ball catch*
13 Drill bit with hexagon shank*
14 Drill bit with SDS-PLUS tool holder*
15 Handle (insulated gripping surface)
16 Socket for charge connector
17 Charge connector
*Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our
accessories program.
4_OPERATING INSTRUCTIONS

PLACEMENT AND TESTING

Setting the Operating Mode
With the selector switch for drilling/hammer drilling 4,
the operating mode of the machine is selected.
Change the operating mode only when the
machine is switched off! Otherwise, the
machine can be damaged.
Capacity
Displayed when the
battery is
charged.
Displayed when the
battery is being charged.
- 23
To change the operating mode, turn the selector
switch for "drilling/hammer drilling" 4 to the requested
position.
Position for hammer drilling in concrete or
stone
Position for drilling without impact in wood,
metal, ceramic and plastic as well as for
screwdriving.
Reversing the Rotational Direction (see figure C)
Actuate the rotational direction switch 8 only when
the machine is at a standstill.
The rotational direction switch 8 is used to reverse the
rotational direction of the machine. However, this is not
possible with the On/Off switch 9 actuated.
Right Rotation: For drilling and driving in screws,
push the rotational direction switch 8 left to the stop.
Left Rotation: For loosening and unscrewing screws
and nuts, press the rotational direction switch 8
through to the right stop.
Switching On and Off
To start the machine, press the On/Off switch 9 and
keep it pressed.
To switch off the machine, release the On/Off switch 9.
For low temperatures, the power tool reaches the full
hammer/impact capacity only after a certain time.
Setting the Speed/Impact Rate
The speed/impact rate of the switched on power tool
can be variably adjusted, depending on how far the
On/Off switch 9 is pressed.
Light pressure on the On/Off switch 9 results in low
speed/impact rate. Further pressure on the switch
increases the speed/impact rate.
GENERAL INSTRUCTIONS FOR USE
For hammer drilling, SDS-PLUS tools are required.
For drilling without impact in wood, metal, ceramic and
plastic, a suitable SDS-PLUS tool or an application
tool with hexagon shank can be used.
For screwdriving, use only screwdriver bits with ball
catch 12. Other screwdriver bits 11 can be inserted via
a universal bit holder with ball catch 10.
A selection of suitable application tools can be found
in the Accessories Overview at the end of these
instructions.
Apply the power tool to the screw/nut only
when it is switched off. Rotating tool inserts
can slip off.
-
es
it
gb
el
de
fr
p
tr