meibes Basic Pro Manual De Instrucciones página 77

1.10 Service Wi...
Disconnect it
and measure
its resistance.
1.10 Service Wi...
With PT1000 sensors
0°C to 100°C
correspond to a
resistance of
1.10 Service Wi...
1000 to 1385 Ohm.
Is your measured
value within
this range?
1.10 Service Wi...
value within
this range?
1.10 Service Wi...
Sensor is faulty
and must be
replaced.
A part of the information and instructions
may be provided in close detail, so that ...
Next
...the texts...
... may well take several screens.
After description of the troubleshooting measure,
the result determined by you is interrogated...
Yes
No
... and the appropriate logical conclusion
is made, the repair work displayed.
After elimination of the malfunction, the plant screen
without the ›Attention‹ symbol appears again
Exit
on the display, automatic mode is continued.
Malfunction
31