Service Parts/Kits List; Troubleshooting - SKF A Serie Instrucciones De Uso

Service parts/kits list

Item Description
1 Grease tube assembly
2 Flexible hose kit
2.1 Cap
2.2 Coupling
2.3 Flexible hose 36 in.(914 mm) with gasket
3 Battery pack 20 V (lithium)
NS* Battery charger (lithium) 220-240 volt
NS Battery charger (lithium) 110 volt
NS Shoulder strap
*
Not shown

Troubleshooting

Condition
Grease gun fails to dispense grease.
Display flashing red due to motor overload.
Grease gun continues to lose prime.
Battery fails to take a charge.
Motor fails to run.
Part number
TLGB 20-4
TLGB 20-3
TLGB 20-2
TLGB 20-5
TLGB 20-6
TLGB 20-1
Cause
Grease tube assembly is out of grease.
Loss of prime.
16
Ball check ( ) is not functioning.
Clogged whip hose.
Blocked lube point.
Clogged whip hose.
Air trapped in several locations in container after bulk
filling.
Follower binding in grease tube assembly.
Check ball seat 16 and check ball dirty.
( )
No power to charger.
Battery may be bad.
Battery needs charging
Faulty wiring to motor.
15
Qty
1
1
1
1
1
1
1
1
Corrective action
Check that grease tube assembly has grease.
Repeat priming operation.
Remove ball check (
seat area.
Clean or replace whip hose. Remove blockages.
Clean or replace whip hose.
Clean or replace whip hose.
Empty grease tube assembly, refill and repeat
priming instructions.
Disassemble grease tube assembly and clean. Be
sure that follower has properly entered the
grease cartridge.
Disassemble grease tube assembly and clean. Be
sure that follower has properly entered the
grease cartridge.
Verify that the follower is not caught on the rim of
the grease cartridge.
Replace grease tube assembly (14) if damaged.
Clean check ball
Check that receptacle has power.
Replace battery.
Recharge battery.
Remove battery, disassemble handle and check
wiring connections on terminal, trigger switch
and motor.
16
), clean and inspect ball
16 and check ball seat.
( )