Changing The Battery; Control Elements - brennenstuhl BLUMO 3000 A Manual De Instrucciones

BLUMO 3000 A
The battery can also be charged with the provided vehicle charging cable (G).
The charging status of the battery is indicated by the battery status indicator (see description
above). If all 4 LEDs are lit, the battery is fully charged.
The light can be used during the charging process. However, it is automatically set to 50 %
brightness and the charging duration of the battery is extended.
If the device is not used for longer periods of time, charge the battery at regular intervals of
approx. 3 months to ensure a long service life.
After charging, always close the charging port with the cover cap.

Changing the battery:

Removal: Press the unlocking buttons with the middle finger and thumb and pull out the battery.
Insertion: Align the electrical connections of the battery and press it in. If the battery is inserted
correctly, it clicks into place.

CONTROL ELEMENTS

A ON/OFF switch
B Bluetooth switch
C Battery status indicator
D Power bank USB charging port
E Charging port
F Power connector
G Vehicle charging cable
MAINTENANCE
CLEANING
Before cleaning, disconnect the fl oodlight from the mains power. Do not use solvents, caustic
cleaning agents or similar products. Only use a dry or slightly moistened cloth for cleaning.
20P135 Mobiler Akku LED Strahler Blumo 3000 A 210217.indd 9 20P135 Mobiler Akku LED Strahler Blumo 3000 A 210217.indd 9
Operating instructions
E
D
C
F
ATTENTION! The LED lamp does not contain
components that require maintenance. The light
source in this lamp cannot be replaced; if the
light source has reached the end of its service
life, the entire lamp has to be replaced. The lamp
may not be opened.
B
A
G
9 9
17.02.2021 18:00:13 17.02.2021 18:00:13