Installation To Solid Concrete Surface - PEERLESS FPEPM-05 Instalación Y Ensamblaje

Installation to Solid Concrete surface

• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
• For attachment to concrete fl oor only. All eight concrete expansion anchors must be used.
• Tighten to 35 ft. • lb (47 N.M.) maximum torque.
Use support column (A) as a template to mark eight mounting holes on concrete fl oor. Drill eight 3/8" (10 mm) dia.
1
pilot holes to a minimum depth of 3" (76 mm) as shown. Place support column over mounting holes and secure
with eight concrete expansion anchors (B) as shown below. Tighten all fasteners.
WARNING
A
B
4 of 24
A
concrete
fl oor
B
Tighten all fasteners. Tighten to
35 ft. • lb (47 N.M.) maximum
torque.
ISSUED: 11-10-10 SHEET #: 061-9060-1