Charging Battery; Important - TENTECH MD10KVx Manual De Uso

3. Charging battery

The MD-10KVx uses a rechargeable LFP (LiFePO4) 12 V - 6000 mAh
battery.
At the end of battery useful life, the battery must be recycled or
disposed of properly, in order to protect the environment.
Charging procedure:
• Check if the MD-10KVx is turned-off and connect it to the mains (AC
adapter).
• The charging indicator ( ) will turn on red and will
remain that way until the battery is totally charged. Then the light will
remain green and keep in that way until the MD-10KVx is disconnected
of the mains.
Use only the AC Adapter provided by the manufacturer. The use of any other
AC Adapter may compromise the equipment safety.
Perform a full charge cycle before using the equipment for the first time, or
after a period without using the equipment (The battery loses some of its
charge being stored).
The rechargeable battery does not have "memory effect" and there are no
restrictions to start charging it as many times as is needed. Charge the battery
before left the equipment in storage and don't let pass more than 30 days without
recharge.
IMPORTANT: while the equipment is connected to the mains supply the START
key is inhibited, so you will not be able to make measurements.
13