Connecting The Md-10Kvx - TENTECH MD10KVx Manual De Uso

4. Connecting the MD-10KVx

ATTENTION: For a safe operation, the procedures detailed below should
be carried out with the device Powered-Off.
Use only the accessories / test leads supplied by the manufacturer.
Using accessories / test leads not provided by the manufacturer may
compromise the equipment safety.
Please, do check there is no difference of potential voltages between the
points where the MD-10KVx shall be connected to. Please, check the
same between those points and the ground.
At the time of the connection and power-on, the equipment automatically
enters in the voltmeter mode and begins to exhibit the circuit voltage in
the display.
The circuit to be tested must be de-energized to avoid interferences in the
measurement. The equipment will block the start of measurement if it
detects a voltage greater than 60 V in the circuit.
14