Pass / Fail" Test Mode - TENTECH MD10KVx Manual De Uso

6.2.4. "Pass / Fail" Test mode


Press key in order to determine the lower insulation limit for type
 
"Pass / Fail" test. Select this value using and keys. Possible
values are 10 MΩ, 100 MΩ, 1 GΩ or 10 GΩ.
During a "Pass/ Fail" test, the MD-10KVx will indicate when the insulation
resistance is lower than the programmed limit, both with an intermittent
 
beep and the key led flashing. The key led will remain flashing
until the end of tests, or until the measurement of the resistance value is
greater than the programmed limit.
22