TENTECH MD10KVx Manual De Uso página 31

Operating instructions
• To start the remote control, go to the screen "Applications" and tap
the icon " TENTECH App".
• A list of paired devices in the tablet will appears, select your device
(MD10KVx [S/N]).
• The TENTECH App will automatically try to establish a
communication with the equipment. If it not succeed, tap the
"CONNECT" button.
Equipment setup
• Tap the "SETUP" button. Will appear a dialog where you can set
all the test parameters (voltage, threshold, timer, SVT, etc.). Tap
the "SAVE" button to confirm.
Performing measurements
• To start a test, hold the button "START" for 3 seconds. During this
time the equipment will sound short beeps.
• To stop the test, tap the "STOP" button.
• After completion of the test, wait a few seconds while the
equipment calculates the capacitance value. If the capacitance
value is "0", no further information will be displayed on the screen.
Lock the remote control
• During the remote control, any direct action taken on the
equipment (eg. Change the test voltage) will lock TENTECH App
functions, except the "Stop" button. The lock is maintained until the
end of the current test.
32