Tabla de contenido
Publicidad
Contre-écrou 3/8 (1)
Guide de câble (1)
Goupilles de tonte ¼-20 x 1-3/4 (6)
Contre-écrous ¼-20 (6)
Contre-écrou 5/16-18 (1)
Contre-écrou ¼-20 (1)
Rondelle en nylon(1)
Boulon de carrosserie 5/16-18 x 5/8 (1)
Ressort (1)
Boulon à épaulement ¼-20 (1)
60
Pour installer la poignée
1. Déplacer la poignée supérieure à la position de
fonctionnement.
2. Positionner la poignée vis-à-vis un des trous de
montage (B) et serrer les boutons de poignée (C)
avec les boulons de carrosserie (D).
B
D
C
680 - 002 - 29.06.2018
5. Install the 5/16'' bolts (A), (C) and tighten (8-12
Ft.Lbs / 11-16 Nm).
A
C
B
6. Install the ¼'' bolts (B) and tighten (4-6 Ft.Lbs / 5-8
Nm).
7. Install the auger belt on the engine pulley. Make sure
that the belt is put correctly around the idler pulley
and installed correctly in the engine pulley groove.
8. Operate all controls to make sure that the auger belt
is installed correctly and that all components are
moving correctly.
To adjust the tension of the cable for
the discharge chute deflector
1. Loosen the jam nuts (B) to adjust the tension of the
cable for the discharge chute adjacent to the
adjuster turnbuckle (A).
A
B
C
2. Hold the short section and turn the long section to
increase the adjuster.
3. Adjust until the cable for the discharge chute
deflector (C) has a tight fit. Tighten the jam nuts.
680 - 002 - 29.06.2018
To adjust the auger control cable
Note If you do not feel comfortable making this
adjustment yourself, please contact an authorized
service center. Adjustments can be needed if the
impeller and auger rotation is sluggish when engaging
the auger control lever, or if the auger belt has been
replaced.
1. Loosen the jam nuts (B) next to the turn buckle (A) to
adjust the cable tension in the auger control cable
(D).
A
B
D
2. Hold the short section and turn the long section.
Turn it 360 degrees.
3. Test the auger engagement. Repeat the adjustment
until only a small amount of tension remains in the
cable when the lever is disengaged.
4. Tighten the bottom jam nut to lock in the tension.
5. Ask an assistant to stand 10 feet / 3 meters in front
of the product, on the opposite side of the chute. The
assistant observes the rotation of the auger and
measures the time it takes for the auger to stop
rotating after the lever is released. If the auger stops
rotating after 5 seconds, adjust the cable by rotating
the center barrel 360 degrees, to contract the
adjuster. Test the auger engagement and measure
the stop time again. If the auger stops rotating in less
than 5 seconds, continue with the next step.
6. Tighten the jam nut on the auger cable.
Note If the adjustment does not resolve the problem,
To remove the auger belt
replace the auger belt. See
on page 20 .
To remove the wheels
1. Remove the wheel pin (A) and the retainer pin (B).
21
Publicidad
Tabla de contenido
