Step 18
NOTE: Before inserting a drawer, be sure the INNER CARTRIDGE in the EXTENSION RAIL on your unit is all the way
å
forward. The INNER CARTRIDGE should click into place against the BLACK TAB.
To insert a drawer into your unit, line up the EXTENSION SLIDES on the drawer with the EXTENSION RAILS on the unit
å
and push the drawer into the unit until the drawer is fully inserted. The drawer will push in hard until it is all the way in, then
it will slide in and out easier.
Slide a RUBBER SLEEVE (2R) over each METAL PIN (1R). Insert the METAL PINS into the hole locations of your choice. Set
å
the ADJUSTABLE SHELVES (H and I) onto the METAL PINS.
Front
Black tab
15 lbs.
I
1R
(16 used)
www.sauder.com/services
Click the inner cartridge into place against the black tab.
Inner cartridge
H
25 lbs.
25 lbs.
40 lbs.
20 lbs.
2R
Extension Rail
135 lbs.
H
25 lbs.
25 lbs.
20 lbs.
40 lbs.
418654
15 lbs.
I
Page 23