Sauder Orchard Hills 418654 Manual De Usuario página 7

Step 2
Separate the EXTENSION SLIDES (Y) from the
å
EXTENSION RAILS (X) as shown in the diagram. Be
prepared, the parts are greasy.
Fasten EXTENSION RAILS (X) to the parts as shown. Use
å
eight GOLD 5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the
å
hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to fi nd the other
hole that lines up with the hole in the UPRIGHTS. Turn a
SCREW into this hole.
Open end
www.sauder.com/services
Y
Push the release lever in and pull the SLIDE from the RAIL.
Finished edge
X
D
E
X
X
X
Finished edge
Open end
418654
X
C
Finished edge
Open end
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
Remember:
Righty tighty.
Lefty loosey.
3S
Page 7