Rowenta DW9280 Manual Del Usuario página 11

7 • Spray
Press the spray button to moisten difficult creases
at any temperature.
8 • nti-Drip system
It prevents water dripping out of the soleplate when the temperature is too low.
9 • uto Off function
• For your safety, the electronic system cuts off the power and the auto off indicator light
flashes fig.11 when:
- The iron remains motionless for more than 8 minutes on its heel
- The iron remains flat or on its side for more than 30 seconds
To restart the iron, just move it gently until the warning light stops flashing.
FTER USE
10 • Emptying
fig.2
Unplug the iron
Set the temperature control dial
11 • Storing
llow the appliance to cool down before winding the cord around the heel. Store the iron
on its heel in a dry and safe place
IMPORT NT Do not wind the cord around the hot soleplate. Never store your iron
placed down on the soleplate.
M INTEN NCE ND CLE NING
Remove the plug from the wall socket and let the iron cool down before
maintenance and cleaning.
12 • nti-scale system
Your iron contains an anti-scale cartridge to reduce scale deposits.
This considerably prolongs the operational life of your iron.
The anti-scale cartridge is an integral part of the water tank and does not need to be
replaced.
13 • Cleaning the iron
When the appliance has cooled down, wipe the iron down with a damp cloth or sponge.
abrasive cleaning agent can be used.
lternatively the ROWENT cleaning kit ZD100 D1 can be used. fter cleaning the soleplate, use
the Self Clean function to remove residues of the cleaner from the steam holes.
IMPORT NT Do not use sharp or abrasive cleaning agents or objects to clean the
soleplate and other parts of the iron.
14 • Self Clean
W RNING : Do not use descaling agents even if advertised for steam irons. They will
permanently damage your iron.
The Self Clean function flushes dirt and scale particles out of the steam chamber.
1. Fill the water tank with untreated tap water up to the max mark and heat the iron to the
••• temperature. Switch off the steam.
2. Unplug the iron and hold it over a sink horizontally.
3. Push the self clean button for 1 minute
now begin to build up. fter a few seconds water will emerge from the soleplate, rinsing
dirt and scale particles out of the steam chamber.
4. Plug in the iron and allow the iron to heat up again. Wait until the remaining water has
evaporated.
5. Unplug from the mains and allow the iron to fully cool down. When cool, the soleplate
can be wiped with a damp cloth.
TIP Use the Self Clean function approx. every 2 weeks. If the water is very hard,
clean the iron weekly.
. Pour away remaining water
fig.3
on position Min. Set the iron on dry position
fig.14
(prolongs the life of the iron)
fig.10 . You can use the spray function
fig.12
.
.
fig.13a-13b
and shake the iron gently: steam will
5
EN
.
non